Engine Oil Change

🛠 Tools & Materials Needed

Step-by-Step Instructions

1. 1

   Run the engine for 5 minutes to warm the oil, which helps it drain more completely.

2. 2

   Shut down the engine and let it cool for 15 minutes so you can handle parts safely.

3. 3

   If using a drain plug: place absorbent pads below, remove drain plug, and drain fully into a pan.

4. 4

   If using an oil extractor pump: insert the extraction tube down the dipstick tube and pump out all oil.

5. 5

   Remove the old oil filter using an oil filter wrench; have rags ready for drips.

6. 6

   Apply a thin film of fresh oil to the new filter gasket before installation.

7. 7

   Install the new filter hand tight, then a quarter-turn more.

8. 8

   Replace drain plug with new washer if applicable.

9. 9

   Add the correct amount and grade of oil per the owner manual.

10. 10

    Run engine for 2 minutes, check for leaks, shut down and recheck oil level on dipstick.